Macpower & Tytech Alumni Uživatelský manuál

External Storage Enclosure for 3.5” Hard DrivePleiades USB/LAN User Manual& Installation Guidev1.1

You can choose to create several partitions through USB but be aware that only the first partition will be recognised on the network (LAN disk funct

The drive has to be formatted using the FAT32 file system. If NTFS is used, the drive will only be recognised on USB. If you use Win2000 or WinXP

The drive has to be formatted using the FAT32 file system (MS-DOS). If Mac OS extended is used, the drive will only be recognised on USB. If you

To connect the LAN disk to your network, an additional switch, router or hub may be required. If you connect the LAN disk to your computer direc

If you forgot your personal login, press and hold the reset button, turn on the device and wait for ten seconds before releasing it. This will rese

The public folder is created by default. You may access it immediately after the system is ready, without any further setup or login. Make sure you

Make sure you are connected to the same network as your LAN disk. If you have assigned a password for your shared folder, please input the correct

If you don’t use the disk utility to format the drive, make sure that you choose the FAT32 file system, otherwise it won’t be recognised on the netwo

Q: My HDD is not recognised. A: Please make sure to set the jumper of your hard drive to Master when you install the drive and then use the disk ut

Table of Contents CHAPTER 1 - INTRODUCTION - 1 - CHAPTER 4 – LAN DISK SETUP - 11 - ICON KEY - 1 - NETWORK INSTALLATION ON A PC - 11 - NETWORK INSTA

Package Content may vary, depending on vendor & version. Chapter 1 - Introduction Icon Key Throughout this manual

If you forgot the login, press and hold the reset button, turn on the device and wait for ten seconds before releasing it. This

Your unit might come with an installed hard drive. Before opening such an enclosure, please read the warranty and any other notes from your vendor

The hard drive jumper settings should be master or factory default. Be careful not to damage any cables or components and double check the conn

Make sure your computer is connected to the same network as your LAN disk. Do not connect the USB and Ethernet cables at the same time! To ass

If the system doesn’t recognize the drive, turn on the power first, before connecting the USB cable. For safe removal of your drive and t

If the system doesn’t recognize the drive, turn on the power first, before connecting the USB cable. For Mac OS 8.6, the USB extension has to be a